There are several points to be noted in the field construction of ditch mold: ① all construction personnel must wear all safety protection measures before the construction site, and the safety helmet must be carefully checked to ensure personal safety before construction. ② The vibrating rod to be used, including the transport cart and tamping equipment, etc., as long as it needs to be plugged in, it needs to be tested in advance to check whether it can be used normally. All kinds of equipment are of great help to the progress of construction. If there is leakage or it can not be used normally, it needs to be replaced immediately. ③ All construction materials are well prepared. After the construction position is determined, the excavation shall be carried out immediately. The production of prefabricated parts shall be carried out through trapezoidal water tank mold, which can ensure that each water tank is complete and qualified, and the surface will not be seriously damaged. Moreover, the processing method of reinforced concrete is adopted, which is made from solid trapezoidal water tank mold and transported to the site smoothly The soil can be backfilled and compacted after the direction and laying direction of the water tank are determined.
During the construction of ditch mold, the qualified prefabricated parts are arranged and placed. These produced rectangular grooves can be used in many places, and the construction parties with many sizes can choose according to different needs. When processing, we must pay attention to some maintenance methods for the mold. The current steel mold has a specified service life Life, or there is a specified number of operations, beyond the use of time, the mold will gradually appear aging problems, and when the mold leaves the factory, the protective coating on the surface will not play a great role. For the maintenance of the prefabricated rectangular groove mold, it is not only after use, but also before and during the operation of the mold. If there is any mistake in any link, it will affect the forming of the rectangular groove, and if the situation is serious, it will cause certain wear of the mold. Therefore, it is necessary to ensure good operation mode when using Correct, also carefully check whether there is large area of rust after disassembling the prefabricated rectangular groove mold, or there is looseness and unsteadiness at the interface, and then clean and repair the mold.