The wind power foundation mold can be reused many times in the production process of concrete components, which greatly speeds up our production speed. The steel mold of wind power foundation base is relatively simple, mostly in rectangular shape. Four side steel plates and one ground steel plate are fixed by manual welding or buckle, so that the overall use effect will be better during production. When the wind power foundation mold is manufactured, the shape and size between welds should be produced according to the requirements of the design drawings, which can better meet our requirements for actual production. In order to ensure that the steel mold plates of the wind power foundation base can be fully welded, we need to clean the steel plates to ensure that every impurity between them will not affect the joint effect. During welding, the overall speed shall be relatively uniform. Before welding, the convex and uneven parts of the edge seam shall be ground flat to avoid undercut. In order to reduce the deformation of the steel die steel plate of the wind power foundation base, we need to adopt the symmetrical welding method in the welding process to avoid the concentration of the stress that the steel plate needs to bear and affect the use of the steel plate.
From the production experience of wind power basic mold manufacturers, no matter what type of steel mold, the manufacturer carries out mold production according to the simple and fast scheme of actual operation after specific drawing design. For example, the small steel mold produced in the past is basically based on simple data such as length, width, height and wall thickness, However, this large precast block requires a high degree of accuracy, so the manufacturer needs the precast block production unit to provide corresponding drawings in order to ensure the accuracy. The production of steel mold for wind power foundation base effectively meets the manufacturing requirements for concrete base.